rebuild · guide 245728 ·
MSI Pulse GL76 Hard Drive (HDD/SSD) + Wi-Fi Replacement
MSI Pulse GL76 · Hard Drive (HDD/SSD) + Wi-Fi · Easy · 300 min · replacement
Replacement / addition of an M.2 SSD or 2.5"...
Steps
- Unscrewing: Remove the single fastener screw located at the end opposite the connector.
Releasing: Let the SSD lift slightly on its own thanks to the spring effect of the port (Warning: be careful of sticky cooling pads if the SSD is equipped with a heat sink; never pull it straight out).
Removing: Once it is slightly tilted, gently pull it backward at an angle of approximately 45 degrees to completely disengage it from its connector. - Slot and ribbon cable: The frame includes a dedicated slot for 2.5-inch SATA storage, with its connection ribbon cable pre-installed from the factory.
Removal of foam: Be sure to remove the protective or packing foam present in the 2.5-inch slot before any installation, otherwise you will not be able to insert the drive or its adapter.
The specific caddy: Installing a drive in this bay requires the use of a steel caddy specific to the frame, generally not included with the Pulse GL76.
Warning: compatibility: Make sure to order a compatible model for the MSI GL76 / GF76 series (or strictly equivalent references). Do not confuse these with older references (such as the GL75 / GF75 frames), because the shape and fasteners are different and it will not fit.
Warning: screws: Certain cad - Disconnect the two antenna wires from the Wi-Fi card, making sure to note their socket numbers on the module.
Remove the fastener screw from the Wi-Fi card (same procedure as for M.2 SSDs).
Tools named by the source
Source and licence
| Source | iFixit — original guide |
|---|---|
| Licence | CC BY-NC-SA 3.0 (CC BY-NC-SA) |
| Retrieved | 2026-10-29 |
| Record | guideid 245728 |
Text steps as retrieved; images and embedded media remain at the source. Text is reproduced under the licence shown above.