{
  "guideid": 245728,
  "title": "MSI Pulse GL76 Hard Drive (HDD/SSD) + Wi-Fi Replacement",
  "summary": "Replacement / addition of an M.2 SSD or 2.5&quot;...",
  "category": "MSI Pulse GL76",
  "subject": "Hard Drive (HDD/SSD) + Wi-Fi",
  "difficulty": "Easy",
  "time_min": 300,
  "type": "replacement",
  "source": "iFixit",
  "source_url": "https://www.ifixit.com/Guide/MSI+Pulse+GL76+Hard+Drive+(HDD-SSD)+++Wi-Fi+Replacement/245728",
  "license": "CC BY-NC-SA 3.0",
  "license_class": "CC BY-NC-SA",
  "license_url": "https://creativecommons.org/licenses/by-nc-sa/3.0/",
  "retrieved": "2026-10-29",
  "body_limit": 12000,
  "artifact_url": "https://rebuild.go-v.org/g/245728",
  "citation": "iFixit. \"MSI Pulse GL76 Hard Drive (HDD/SSD) + Wi-Fi Replacement.\" iFixit, https://www.ifixit.com/Guide/MSI+Pulse+GL76+Hard+Drive+(HDD-SSD)+++Wi-Fi+Replacement/245728. CC BY-NC-SA 3.0 (CC BY-NC-SA). Retrieved 2026-10-29. Via rebuild.go-v.org/g/245728.",
  "body_characters": 1435,
  "truncated": false,
  "steps": [
    "Unscrewing: Remove the single fastener screw located at the end opposite the connector. Releasing: Let the SSD lift slightly on its own thanks to the spring effect of the port (Warning: be careful of sticky cooling pads if the SSD is equipped with a heat sink; never pull it straight out). Removing: Once it is slightly tilted, gently pull it backward at an angle of approximately 45 degrees to completely disengage it from its connector.",
    "Slot and ribbon cable: The frame includes a dedicated slot for 2.5-inch SATA storage, with its connection ribbon cable pre-installed from the factory. Removal of foam: Be sure to remove the protective or packing foam present in the 2.5-inch slot before any installation, otherwise you will not be able to insert the drive or its adapter. The specific caddy: Installing a drive in this bay requires the use of a steel caddy specific to the frame, generally not included with the Pulse GL76. Warning: compatibility: Make sure to order a compatible model for the MSI GL76 / GF76 series (or strictly equivalent references). Do not confuse these with older references (such as the GL75 / GF75 frames), because the shape and fasteners are different and it will not fit. Warning: screws: Certain cad",
    "Disconnect the two antenna wires from the Wi-Fi card, making sure to note their socket numbers on the module. Remove the fastener screw from the Wi-Fi card (same procedure as for M.2 SSDs)."
  ],
  "tools": []
}