{
  "guideid": 245730,
  "title": "Tailgate (trunk) gas strut replacement.",
  "summary": "Replacing the tailgate gas struts on a...",
  "category": "2008-2013 Volvo V70 (pre-facelift)",
  "subject": "Tailgate shock absorber(s). Gas struts. Trunk shock absorber(s).",
  "difficulty": "Moderate",
  "time_min": 7200,
  "type": "replacement",
  "source": "iFixit",
  "source_url": "https://www.ifixit.com/Guide/Tailgate+(trunk)+gas+strut+replacement./245730",
  "license": "CC BY-NC-SA 3.0",
  "license_class": "CC BY-NC-SA",
  "license_url": "https://creativecommons.org/licenses/by-nc-sa/3.0/",
  "retrieved": "2026-10-29",
  "body_limit": 12000,
  "artifact_url": "https://rebuild.go-v.org/g/245730",
  "citation": "iFixit. \"Tailgate (trunk) gas strut replacement..\" iFixit, https://www.ifixit.com/Guide/Tailgate+(trunk)+gas+strut+replacement./245730. CC BY-NC-SA 3.0 (CC BY-NC-SA). Retrieved 2026-10-29. Via rebuild.go-v.org/g/245730.",
  "body_characters": 2122,
  "truncated": false,
  "steps": [
    "Remove the headliner (partially) There is no need to remove the headliner completely. It is sufficient to remove the plastic panels on the sides and top of the trunk. This will allow you to pull the headliner down slightly to access the upper strut mounts. To do this, you may need to remove the rear interior light, unscrew the Torx screws, and detach the side trunk trim panels. Locate the mounts Look into the gap created between the headliner and the body. You will see the gas strut secured at both ends. Each end is held in place by a metal retaining clip (cotter pin) inserted into a hole.",
    "Secure the door Please use an assistant; a falling door can injure you very severely! Remove the clips Take a prepared hook (or an awl with a bent tip). Insert it under the metal spring clip at the end of the support and  pry it up . The clip should pop out easily. Do not worry if it gets bent—new supports will come with their own clips. Detach the support Remove the clips from both ends of the support (first from the door, then from the body). After this, the support can be easily removed. First, detach it from the door, and then pull it out of the mounting on the body.",
    "Prepare the new support strut Remove the shipping clips from the new support strut. You may need to rotate the tip of the strut slightly so that it aligns precisely with the mounting point on the body. Install the support strut First, push the support strut onto the hinge on the door side. Ensure that it is seated firmly and completely. Then, with the help of an assistant, lift the door even higher and push the second end of the support strut onto the hinge on the body side. It should also click into place. Secure the support strut Insert the new retaining clips (cotter pins) into the holes on both ends of the support strut to secure it.",
    "Repeat the procedure for the second support. After installing both supports, check the door operation: it should open smoothly and be held securely in the open position. If everything works correctly, reinstall all removed trim elements in the reverse order of removal."
  ],
  "tools": []
}